Installation Guide

3. Route the Wiring
Recess-Mount Installation
Drill a 3/4″ (19 mm) hole into each side of the framed cavity, located 4-5/8″ (117 mm) from the
bottom of the cavity.
Route the electrical wiring from the GFCI/RCD receptacle and the dimmer switch through the holes
in the framing.
The wiring should extend at least 20″ (508 mm) from each hole.
Surface-Mount Installation
Drill two 3/4” (19 mm) holes for the electrical wire locations.
Route the electrical wiring from the GFCI/RCD receptacle and the dimmer switch through the holes
in the finished wall.
The wiring should extend at least 20″ (508 mm) from each hole.
20"
(508 mm)
20"
(508 mm)
Ø 3/4"
(19 mm)
Recess-Mount Installation
Surface-Mount Installation
Ø 3/4"
(19 mm)
4-5/8"
(117 mm)
Kohler Co. 7 1267931-2-F