Installation Guide

3. Complete the Installation
IMPORTANT! Make drip loops in all cables.
IMPORTANT! Disconnect the power from the controller before
connecting the cables.
Connect the interface cable to the controller. Ensure the cable fully
clicks into the socket.
The interface is powered by the controller. The interface should
illuminate when power is connected to the controller.
If not already installed, install any components for your system
configuration.
Before Operating the System For the First Time:
Download and install the latest software. This may take an hour or
more to complete based on system configuration and internet
connection speed. Do not disconnect the power from the controller
during software download and installation.
Drip Loop
Controller
Connect up to
three interfaces.
Disconnect the
power before
connecting the
cables.
1194161-2-A 6 Kohler Co.