Installation Guide

4. Download/Install Software
NOTICE: Software download and installation may take an hour or
more to complete based on system configuration and internet
connection speed. Do not disconnect the power from the controller
during software download and installation.
NOTE: Internet service is required to receive the latest updates for
system components. The components must be connected to the
controller prior to software download.
Disconnect the power from the controller.
Make sure all system components are connected to the controller.
Attach the ferrite (provided) to the Ethernet cable, close to the
end that will be connected to the controller.
Connect the Ethernet cable from the controller to a router with
active internet service.
Reconnect the power supply to the controller. The controller will
communicate with the router to receive an IP address.
Upon receiving an IP address, the controller will check for
software updates for any connected components, and will
automatically download and install the software. Do not
disconnect the power from the controller during software
download and installation.
Power Cord
To
Router
Ethernet
Cable
Ferrite
Kohler Co. 9 1218131-2-A