Installation Guide

8. Complete the Installation
IMPORTANT! Make drip loops in all cables.
IMPORTANT! Make sure all cables fully click into the sockets.
Connect the data cable(s) from the adapter into the eight-port
section of the controller.
Connect the 30’ (9.14 m) valve cable into a valve port on the
controller.
Connect the 8-pin end of the valve cable to the valve.
Reconnect the power cable to the valve.
Verify all grommets are in place, then reinstall the door to the
valve.
To close the door, press on the tabs until the clips snap in place.
Turn on the power to the valve and connect the power to the
controller.
The interface is powered by the controller. The interface should
illuminate when power is connected to the controller.
Data
Cables
Power
Cable
Valve
Cable
To
Adapter
Valve Cable
Controller Digital Valve
Drip Loop
Kohler Co. 11 1233354-2-B