Installation Guide

5. Install the Housing Assembly
CAUTION: Risk of product damage: Before proceeding, verify that
both ends of the original cable coming from the wall are
disconnected from any components.
Apply grease (provided with the DTV+ interface) into both ends
of the coupler.
Connect the 18″ (457 mm) retrofit cable and the interface cable to
the coupler. Make sure the cables fully click into the coupler.
Connect the other end of the retrofit cable to the cable from the
wall. Align the white arrows on the connectors and make sure
they fully engage.
Carefully feed the cables and coupler into the hole in the wall.
Firmly press the housing assembly into the wall sleeve until it
snaps in place.
Repeat the steps above for any accessory interfaces.
Coupler
18" (457 mm)
Retrofit Cable
Apply grease
in both ends.
1233354-2-B 8 Kohler Co.