Specification

Residential/Light Commercial Generator Accessories
Load Management
D The Load Control Module (LCM) sheds loads to prevent
generator overload, in compliance with NEC 2008.
D The LCM monitors generator current and frequency to
determine when to shed loads. This monitoring prevents
frequency drops that can damage valuable electronics like
computers and televisions.
D Load management with the LCM allows the use of a smaller
generator set.
Priority Setting
D Loads are added and shed according to their priority. Load 1 is
the top priority, which is added first and shed last. Load 6 is the
lowest priority.
D Less critical loads can be turned off automatically when
essential appliances are running.
D Load priorities are hard-wired at installation.
Standard Features
D The LCM can be used with Kohler generator sets equipped
with the RDC2 or DC2 controller, including the following
models:
d 14RESA and 14RESAL
d 20RESA and 20RESAL
d 38RCL
d 48RCL
D Automatically manages up to six residential loads:
d Four power relays for management of non-essential
secondary loads. T wo 50 amp loads and two 40 amp
loads can be connected.
d Two HVAC relays to control two independent air
conditioner loads.
D User interface for load status indication:
d An industry first: Test button allows the operator to cycle
the relays in the order of their priority (only functions
when the generator set is in RUN mode).
d Dual color LEDs for each load indicate load status
(powered or shed) and flash to indicate a test.
D NEMA 3R aluminum enclosure for indoor or outdoor
installation.
D Available with two wiring options:
d With 2-foot color-coded pre-wired harness for easy
installation of the LCM next to the distribution panel.
d With terminal block connections for installation of the
LCM in any location.
D UL listed
Load Control Module (LCM)
LCM with Pre-Wired Harness
LCM with Terminal Block Connections
G6-120 12/12b