Specifications

Ø 2-1/8"
Notes
Required Electrical Service
Install this product according to the installation
instructions.
One circuit required, protected with Class A Ground-Fault
Circuit-Interrupter (GFCI) or Residual Current Device (RCD).
A 1-1/4" (32 mm) minimum to 1-1/2" (38 mm)
maximum diameter mounting hole is required.
120/240 V, 50/60 Hz
Technical Information
The minimum distance between the back of the
faucet spout and the wall must be 1-3/4" (44 mm).
All product dimensions are nominal.
Hardwire - AC and Plug - AC, not includedPower source:
This will allow proper clearance for setscrew
access.
Faucet:
0.5 gal/min (1.9 l/min)Flow rate:
The maximum distance between the bathroom
sink basin edge to the base of the faucet spout
must be 1-3/4" (44 mm).
60 psi (4.1 bar)Pressure:
Cast brassValve body:
This product requires an AC power supply (not
included).
YesDrain included:
Spout:
ADA, OBC, CSA B651 compliant when installed
to the specific requirements of these regulations.
5-13/16" (147 mm)Spout reach:
1-800-4KOHLER (1-800-456-4537)
Kohler Co. reserves the right to make revisions without notice to product specifications.
For the most current Specification Sheet, go to www.kohler.com.
1-31-2019 09:28 - US/CA/MX
Composed
®
faucet with Kinesis
™
sensor, AC-powered
K-103C36-SANA