Rough-In Guide

Product Information
Applicable product:
Bath whirlpool with Massage Experience K-1110-M
Fixture:*
Bathing well:
Basin area, bottom 42″ (106.7 cm) x 25-1/2″ (64.8 cm)
Basin area, top 63″ (160 cm) x 31-1/2″ (80 cm)
Weight 160 lbs (72.6 kg)
To overflow:
Water depth to rim 19-1/4″ (48.9 cm)
Capacity 96 gal (363.4 L)
* Approximate measurements for comparison only.
Included component:
Cut-out template 1016369-7
Pump Heater V Hz A
1.5 kW 240 50/60 15
Required accessories:
Clearflo horizontal overflow bath drain K-7273
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual
Current Device (RCD):
Pump/control 220/240 V, 20 A, 50/60 Hz
Installation Notes
Install this product according to the installation guide.
Pump/piping protrudes beyond rim (see below).
Floor support under whirlpool must provide a minimum of 43
lbs/square foot (209 kg/square meter) loading.
Hot water supply should be 70% of capacity or greater.
Installations will vary.
Fixture conforms to ANSI Standard Z124.1.2. All dimensions
are nominal.
72" (182.9 cm)
6" (15.2 cm)
7/16" (1.1 cm)
1-1/2" OD
Note: Pump/Piping Protrudes Beyond Rim
No change in measurements
with drain shown. (K-7273)
46"
(116.8 cm)
2-3/4" (7 cm) Max
Pump/Control Access
34" (86.4 cm) W x
15" (38.1 cm) H Min
23-3/16"
(58.9 cm)
22"
(55.9 cm)
1-3/16"
(3 cm)
1-3/8"
(3.5 cm)
23"
(58.4 cm)
3-15/16"
(10 cm)
12-3/16"
(31 cm)
6-3/8"
(16.2 cm)
Roughing-In
K-1110-M
PURIST
®
BATH WHIRLPOOL WITH MASSAGE EXPERIENCE
PURIST
®
BATH WHIRLPOOL WITH MASSAGE EXPERIENCE
1023257-1-
E