Specification Sheet

1-1/4"
Notes
Required Electrical Service
Measure your actual product for rough-in details.
Two dedicated circuits required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual Current Device
(RCD).
Install this product according to the installation
instructions.
The hot water supply should be 70% of the
capacity of the bath or greater. Installations will
vary.
120 V, 15 A, 60 HzPump:
120 V, 15 A, 60 HzHeater:
Technical Information
Provide one grounded electrical outlet within 24"
(610 mm) of each component.
All product dimensions are nominal.
Under-mountInstallation:
If installing a rim-mount faucet, make sure there
is no interference with drain overflow before
EndDrain location:
43" x 20-1/2" (1092 mm x 521 mm)Basin area, bottom:
drilling any holes. Consult local and national
53-1/2" x 32-1/8" (1359 mm x 816 mm)Basin area, top:
codes for minimum air gap requirements if
installing a spout on the faucet deck.
110 lbs (49.9 kg)Weight:
35 lbs/ft² (170.9 kg/m²)Minimum floor load:
15" (381 mm)Water depth:
57 gal (215.8 L)Water capacity:
Tile-in, 58-1/2" x 40-1/2" (1486 mm x
1029 mm)
Cutout:
Pump: 120 V, 7.5 A, 60 Hz
Heater: 120 V, 12.5 A, 60 Hz, 1500 W
Electrical component
rating:
SinglePump speed:
USA/Canada: 1-800-4KOHLER (1-800-456-4537)
Kohler Co. reserves the right to make revisions without notice to product specifications.
For the most current Specification Sheet, go to www.kohler.com.
3-7-2017 04:34
Windward
®
5' Whirlpool Bath
K-1112-FH