Specification

Technical Information
Fixture*:
Bathing well:
Basin area
bottom
43″ (1092 mm) x 20-1/2″ (521 mm)
Basin area
top
53-1/2″ (1359 mm) x 32-1/8″ (816 mm)
Weight 120 lbs (55 kg)
To overflow:
Water depth 15″ (381 mm)
Capacity 57 gal (215.9 L)
* Approximate measurements for comparison only.
Drop-in cutout dimensions:
58-1/2″ (1486 mm) x 40-1/2″ (1029 mm)
Blower motor Heater V Hz A
300 W 120 60 5
Required Electrical Service
Dedicated circuit required, protected with a Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump/control 120 V, 5 A, 60 Hz
Locate the outlet behind the bath and within 24″ (610
mm) of the pump.
Installation Notes
Install this product according to the installation guide.
Floor support under this must provide for a minimum of 36
lbs/square foot (174 kg/square meter) loading.
If installing a rim-mount faucet, make sure there is no
interference with the drain overflow and circulating system
before drilling any holes. Consult local and national codes for
minimum air gap requirements if installing a spout on the
faucet deck.
2-7/8"
(73 mm)
3"
(76 mm)
Recommended faucet area
1-1/2" OD
42" (1067 mm)
21"
(533 mm)
10-13/16"
(275 mm)
60" (1524 mm)
21"
(533 mm)
3-1/8"
(79 mm)
1-1/4" (32 mm)
3-1/2" (89 mm)
1" (25 mm) from the
Floor to the Bottom
of the Drain
Blower/Control Access
20" (508 mm) W x
15" (381 mm) H Min
No change in measurements if connected with
drain illustrated. (K-11677)
1-1/4"
(32 mm)
Tile Flange
Detail
1-1/4" (32 mm)
Product Diagram
WINDWARDTM
WINDWARDTM BATH WITH AIRJETS
Page2of2
1079329-4-
E