Specification

Technical Information
Fixture*:
Bathing well
Basin area
bottom
55″ (1397 mm) x 23-1/4″ (591 mm)
Basin area
top
64″ (1626 mm) x 32″ (813 mm)
Weight 132 lbs (60 kg)
To overflow
Water depth 15″ (381 mm)
Capacity 78.5 gal (297 L)
* Approximate measurements for comparison only.
Blower motor Heater V Hz A
300 W 120 60 5
Minimum access panel blower motor:
20″ (508 mm) W x 15″ (381 mm) H required
Required Electrical Service
Dedicated circuit required, protected with a Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump/control 120 V, 5 A, 60 Hz
Locate the outlet behind the bath and within 24″ (610
mm) of the pump.
Installation Notes
Install this product according to the installation guide.
Floor support under this product must provide for a minimum
of 39 lbs/square foot (190 kg/square meter) loading.
If installing a rim-mount faucet, make sure there is no
interference with the drain overflow and circulating system
before drilling any holes. Consult local and national codes for
minimum air gap requirements if installing a spout on the
faucet deck.
Recommended faucet area
2-7/8"
(73 mm)
3"
(76 mm)
72" (1829 mm)
42" (1067 mm)
1-1/2" OD
1-1/4" (32 mm)
No change in measurements if connected with
drain illustrated. (K-11677)
Tile Flange
Detail
1-1/4"
(32 mm)
Blower/Control Access
20" (508 mm) W x
15" (381 mm) H Min
21"
(533 mm)
1" (25 mm) from
the Floor to the
Bottom of the Drain
21"
(533 mm)
3-3/4"
(95 mm)
11-1/16"
(281 mm)
1-1/4"
(32 mm)
3-1/2"
(89 mm)
Product Diagram
WINDWARDTM
WINDWARDTM BATH WITH AIRJETS, INTEGRAL APRON
Page2of2
1079332-4-
D