Specification

Technical Information
Fixture*: basin area top area weight
Bathing well 55″ (139.7
cm) x 23-1/4″
(59.1 cm)
64″ 162.6 cm)
x32″(81.3
cm)
132
lbs (60
kg)
water depth capacity
To overflow 15″ (38.1 cm) 78.5 gal (297 L)
* Approximate measurements for comparison only.
Drop-in cut-out dimensions:
70-1/2″ (179.1 cm) x 40-1/2″ (102.9 cm)
Pump: Hp V Hz A
1-speed 1.25 120 60 7.5
Heater kW V Hz A
1.5 120 60 12.5
Minimum access panel pump/control:
20″ (50.8 cm)Wx15″(38.1 cm) H required
Required Electrical Service (2
required)
Two dedicated circuits required, both protected with a
Class A Ground-Fault Circuit-Interrupter (GFCI):
Pump/control 120 V, 15 A, 60 Hz
Heater 120 V, 15 A, 60 Hz
Locate the outlets behind the whirlpool and within 24″ (61
cm) of the pump and, if supplied, heater.
Installation Notes
Install this product according to the installation guide.
Floor support under the whirlpool must provide for a minimum
of 80 lbs/square foot (390 kg/square meter) loading.
If installing a rim-mount faucet, make sure there is no
interference with the drain overflow and circulating system
before drilling any holes. Consult local and national codes for
minimum air gap requirements if installing a spout on the
faucet deck.
Pump/Control Access
72" (182.9 cm)
42" (106.7 cm)
1-1/2" OD
3/8" (1 cm)
21"
(53.3 cm)
3-1/2"
(8.9 cm)
2-7/8" (7.3 cm)
3" (7.6 cm)
Recommended faucet area
No change in measurements if connected with
drain illustrated. (K-11677 or K-11677M)
19-1/2"
(49.5 cm)
1-1/2"
(3.8 cm)
Drop-In Rim
Detail
1-1/4"
(3.2 cm)
Tile Flange
Detail
1-1/2"
(3.8 cm)
11-1/16" (28.1 cm)
3-3/4"
(9.5 cm)
Product Diagram
WINDWARDTM
WINDWARDTM BATH WHIRLPOOL WITH HEATER
Page2of2
1047221-4-
B