Specification

Technical Information
Fixture*:
Bathing well:
Basin area, bottom 55″ (1397 mm) x 23-1/4″ (591 mm)
Basin area, top 64″ 1626 mm) x 32″ (813 mm)
Weight 132 lbs (60 kg)
To overflow:
Water depth 15″ (381 mm)
Capacity 78.5 gal (297 L)
* Approximate measurements for comparison only.
Pump: V Hz A
1-speed 120 60 7.5
Minimum access panel pump/control:
20″ (508 mm) W x 15″ (381 mm) H required
Required Electrical Service
Dedicated circuit required, protected with a Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump/control 120 V, 15 A, 60 Hz
Locate the outlet behind the whirlpool and within 24″
(610 mm) of the pump.
Installation Notes
Install this product according to the installation guide.
Floor support under the whirlpool must provide for a minimum
of 39 lbs/square foot (189 kg/square meter) loading.
If installing a rim-mount faucet, make sure there is no
interference with the drain overflow and circulating system
before drilling any holes. Consult local and national codes for
minimum air gap requirements if installing a spout on the
faucet deck.
72" (1829 mm)
42" (1067 mm)
3/8" (10 mm)
2-7/8"
(73 mm)
3"
(76 mm)
Recommended faucet area
21"
(533 mm)
1-1/4"
(32 mm)
11-1/16"
(281 mm)
21"
(533 mm)
3-3/4"
(95 mm)
1-1/4"
(32 mm)
3-1/2"
(89 mm)
No change in measurements if connected
with drain illustrated. (K-11677)
Tile Flange
Detail
1-1/4"
(32 mm)
1-1/2" OD
Product Diagram
WINDWARD
®
WINDWARD
®
BATH WHIRLPOOL WITH INTEGRAL APRON
Page2of2
1047224-4-
D