Installation Sheet

3. Make the Electrical Connections
DANGER: Risk of electric shock. Connect the blower motor, and bubble heater to properly
grounded, grounding-type receptacles protected by a Ground-Fault Circuit-Interrupter (GFCI)*. Do
not remove the grounding pins from the plugs. Do not use grounding adapters.
WARNING: Risk of electric shock. Make sure the power has been disconnected before performing
the following procedures.
NOTICE: The blower and bubble heater are equipped with cords and plugs. A qualified electrician must
install two GFCI*-protected, 120 V, 15 A, grounded outlets. No other load should be on these circuits. The
blower and bubble heater should not be combined onto one circuit.
Install two GFCI*-protected electrical outlets within reach of the 24″ (610 mm) power cords.
Plug the blower cord into one of these GFCI*-protected outlets.
*Outside North America, this device may be known as a Residual Current Device (RCD).
Kohler Co. 7 1385105-2-B
24" (610 mm) Max. Distance