Specification Sheet

3-1/8"
Notes
Required Electrical Service
Measure your actual product for rough-in details.
Two dedicated circuits required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual Current Device
(RCD).
Install this product according to the installation
instructions.
The hot water supply should be 70% of the
capacity of the bath or greater. Installations will
vary.
120 V, 15 A, 60 HzBlower, Heated
Surface:
120 V, 15 A, 60 HzHeater:
Provide one grounded electrical outlet within 24"
(610 mm) of each component.
Technical Information
All product dimensions are nominal.
This product is designed for drop-in installation
only. It is not suited for use in a three-wall alcove
with an overhead shower.
Drop-inInstallation:
45-1/8" x 19-11/16" (1146 mm x 500 mm)Basin area, bottom:
52-3/4" x 30-1/2" (1340 mm x 775 mm)Basin area, top:
Remote blower installation kit is available for
relocating the blower. Provide access for servicing
the blower.
90 lbs (40.8 kg)Weight:
45 lbs/ft² (219.7 kg/m²)Minimum floor load:
Do not relocate or alter the PVC tee or coiled
flexible tubing connected to the blower. Follow
the blower relocation instructions exactly.
15" (381 mm)Water depth:
58 gal (219.6 L)Water capacity:
Blower: 120 V, 10 A, 60 Hz
Heated Surface: 120 V, 0.5 A, 60 Hz
Heater: 120 V, 5 A, 60 Hz, 620 W
Electrical component
rating:
ADA compliant when installed to the specific
requirements of these regulations.
2-3/16" (56 mm)Minimum flat for door:
1-800-4KOHLER (1-800-456-4537)
Kohler Co. reserves the right to make revisions without notice to product specifications.
For the most current Specification Sheet, go to www.kohler.com.
3-30-2019 03:40 - US
Archer
®
drop-in Heated BubbleMassage
™
air bath with Bask
®
K-1122-GHW