Specification

Technical Information
Fixture*:
Bathing well:
Basin area,
bottom
45-1/8″ (1146 mm) x 19-11/16″ (500 mm)
Basin area,
top
52-3/4″ (1340 mm) x 25-5/16″ (643 mm)
Weight 106 lbs (48.1 kg)
To overflow:
Water depth 15″ (381 mm)
Capacity 58 gal (219.5 L)
* Approximate measurements for comparison only.
WV HzA
Blower motor 300 120 60 10
Heated
surface
65 120 60 .5
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI).
Blower/Heated surface 120 V, 15 A, 60 Hz
Blower motor and heated surface are supplied with
separate 24″ (610 mm) grounding-type plug-in cords.
Installation Notes
Install this product according to the installation guide.
Floor support under this product must provide for a minimum
of 46 lbs/square foot (223 kg/square meter) loading.
NOTICE: Relocation of the blower motor and check valve is
optional. Mount the blower motor and check valve together;
do not move one without the other. An additional access
panel is required for relocation. Provide an access panel at
the blower motor/control location.
Locate a GFCI-protected 120 V, 15 A, grounded duplex
electrical outlet within 24″ (610 mm) of the blower motor.
Will comply with ADA when installed per Section 607
Bathtubs of the ADA 2010 Standards for Accessible Design.
1/2" (13 mm) R.
1-1/2"
Bath Drain
60" (1524 mm)
3/4" (19 mm)
2-1/2"
(64 mm)
16"
(406 mm)
11-1/4"
(286 mm)
Integral Flange
Detail
1-1/4"
(32 mm)
No change in measurements if connected with
drain illustrated. (K-7271 or K-7272)
3/4" (19 mm)
4-1/8"
(105 mm)
1-1/4"
(32 mm)
Lumbar
Angle
25˚
32"
(813 mm)
19"
(483 mm)
20-1/4"
(514 mm)
Product Diagram
ARCHER
®
ARCHER
®
5’ BUBBLEMASSAGETM BATH WITH BASKTM HEATED SURFACE
Page2of2
1201679-4-
B