Specification

Technical Information
Fixture*:
Bathing well:
Basin area,
bottom
45-1/8″ (1146 mm) x 19-11/16″
(500 mm)
Basin area, top 52-3/4″ (1340 mm) x 25-5/16″
(643 mm)
Weight 90 lbs (40.8 kg)
To overflow:
Water depth 15″ (381 mm)
Capacity 58 gal (219.5 L)
* Approximate measurements for comparison only.
Drop-in cutout 58-1/2″ (1486 mm) x 30-1/2″ (775 mm)
WV HzA
Blower motor 300 120 60 10
Heated
surface
65 120 60 .5
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI).
Blower/Heated surface 120 V, 15 A, 60 Hz
Blower motor and heated surface are supplied with
separate 24″ (610 mm) grounding-type plug-in cords.
Installation Notes
Install this product according to the installation guide.
Floor support under this product must provide for a minimum
of 45 lbs/square foot (218 kg/square meter) loading.
This product is designed for a drop-in installation only. It is not
suited for use in a three-wall alcove with an overhead shower.
NOTICE: Relocation of the blower motor and check valve is
optional. Mount the blower motor and check valve together;
do not move one without the other. Two access panels are
required for blower motor and check valve relocation. Provide
one access panel at the blower motor/control location and
another at the heated surface location.
Will comply with ADA when installed per Section 607
Bathtubs of the ADA 2010 Standards for Accessible Design.
32" (813 mm)
60" (1524 mm)
1-1/2"
Bath Drain
3/4" (19 mm)
No change in measurements if connected
with drain illustrated. (K-7271 or K-7272)
Drop-In Rim
Detail
1-1/2"
(38 mm)
19"
(483 mm)
11-1/4"
(286 mm)
16"
(406 mm)
2-1/2"
(64 mm)
Blower Motor Access
30" (762 mm) W x
15" (381 mm) H Min
4-1/8"
(105 mm)
Lumbar
Angle
25˚
20-1/2"
(521 mm)
1-1/2"
(38 mm)
Product Diagram
ARCHER
®
ARCHER
®
5’ BUBBLEMASSAGETM BATH WITH BASKTM HEATED SURFACE
Page2of2
1201680-4-
B