Specification

Technical Information
Fixture*:
Bathing well
Basin area, bottom 51-3/8″ (1305 mm) x 21″ (533 mm)
Basin area, top 64-1/2″ (1638 mm) x 30-1/2″
(775 mm)
Weight 100 lbs (45.4 kg)
To overflow
Water depth 15″ (381 mm)
Capacity 72 gal (273 L)
* Approximate measurements for comparison only.
Drop-in cutout 70-1/2″ (1791 mm) x 34-1/2″ (876 mm)
Blower
motor:
Heater V Hz A
300 W 120 60 5
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Blower motor: 120 V, 15 A, 60 Hz
Blower motor is supplied with a 24″ (610 mm)
grounding-type plug-in cord.
Installation Notes
Install this product according to the installation guide.
NOTICE: Relocation of the blower motor and check valve is
optional. Only mount the blower motor and check valve
together. Do not move one without the other.
NOTICE: Two access panels are required for blower motor
and check valve relocation. Provide one access panel at the
blow motor/control location and another at the control box.
Floor support under this product must provide for a minimum
of 41 lbs/square foot (197 kg/square meter) loading.
The hot water supply should be 70% of the capacity of the
bath or greater. Installations will vary.
Not suited for a three-wall alcove with an overhead shower.
Will comply with ADA when installed per Section 607
Bathtubs of the Act.
36" (914 mm)
72" (1829 mm)
3/4" (19 mm)
1-1/2"
Bath Drain
2-1/2"
(64 mm)
11-1/4"
(286 mm)
1-1/4"
(32 mm)
18"
(457 mm)
Required Blower Motor Access
20" (508 mm) W x 15" (381 mm) H
No change in measurements if connected
with drain illustrated. (K-7272)
1-1/2"
(38 mm)
Drop-In
Rim Detail
19"
(483 mm)
4-1/8"
(105 mm)
Product Diagram
ARCHERTM
ARCHERTM 6’ (1.8 m) BUBBLEMASSAGETM BATH
Page2of2
1071368-4-
E