Specification

Technical Information
Fixture*:
Bathing well
Basin area bottom 51-3/8″ (130.5 cm) x 21″ (53.3 cm)
Basin area top 64-1/2″ (163.8 cm) x 30-1/2″
(77.5 cm)
Weight 110 lbs (50 kg)
To overflow
Water depth 15″ (38.1 cm)
Capacity 72 gal (273 L)
* Approximate measurements for comparison only.
Drop-in cutout dimensions:
70-1/2″ (179.1 cm) x 34-1/2″ (87.6 cm)
Pump: Hp V Hz A
1-speed 1.25 120 60 7
Heater: kW V Hz A
1.5 120 60 12.5
Pump is supplied with 24” (61 cm) grounding-type plug-in
cord.
Minimum access panel pump/control:
20″ (50.8 cm) W x 15″ (38.1 cm) H required
Required Electrical Service
(2 required)
Two dedicated circuits required, each protected with
Class A Ground-Fault Circuit-Interrupter (GFCI):
Pump/control 120 V, 15 A, 60 Hz
Heater 120 V, 15 A, 60 Hz
Installation Notes
Install this product according to the installation guide.
Floor support under this product must provide for a minimum
of 41 lbs/square foot (201 kg/square meter) loading.
This product is designed for drop-in installation only. It is not
intended for use in a three-wall alcove with an overhead
shower.
The hot water supply should be 70% of the capacity of the
bath or greater. Installations will vary.
No change in measurements if connected
with drain illustrated. (K-7272)
36" (91.4 cm)
72" (182.9 cm)
11-1/4"
(28.6 cm)
19"
(48.3 cm)
1-1/2" OD
3/4" (1.9 cm)
18"
(45.7 cm)
2-1/2"
(6.4 cm)
1-1/4"
(3.2 cm)
1-1/2"
(3.8 cm)
Drop-in Rim
Detail
Pump/Control Access
Product Diagram
ARCHERTM
ARCHERTM 6’ (1.8 m) BATH WHIRLPOOL WITH HEATER
Page2of2
1071365-4-
C