Rough-In Guide

Product Information
Applicable product:
Custom bath whirlpool with heater – drop-in K-1139-HN
Fixture*:
Bathing well:
Basin area 46″ (116.8 cm) x 15″ (38.1 cm)
Top area 55″ (139.7 cm) x 25″ (63.5 cm)
Weight 60 lbs (27.2 kg)
To overflow:
Water depth 14″ (35.6 cm)
Capacity 57 gal (215.8 L)
* Approximate measurements for comparison only.
Drop-in cutout 58-1/2″ (148.6 cm) x 34-1/2″ (87.6 cm)
Pump: V Hz A
1-speed 120 60 7.5
Heater: kW V Hz A
1.5 120 60 12.5
Required Electrical Service
Two dedicated circuits required, each protected with
Class A Ground-Fault Circuit-Interrupter (GFCI):
Pump/control 120 V, 15 A, 60 Hz
Heater 120 V, 15 A, 60 Hz
Locate the outlets behind the whirlpool and within 24″
(61 cm) of the pump.
Installation Notes
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of
37 lbs/square foot (183 kg/square meter) loading.
The apron must be installed before the finished floor and wall
materials are installed.
Pump must be relocated to custom position at the time of
installation. Provide adequate clearance.
Fixture conforms to ANSI Standard Z124.1.2. All dimensions
are nominal.
7-1/2"
(19.1 cm)
Max
1-1/2"
(3.8 cm)
Drop-in Rim
Detail
Pump/Control
Access
20" (50.8 cm) W x
15" (38.1 cm) H
3" (7.6 cm)
2-1/2"
(6.4 cm)
60" (152.4 cm)
36" (91.4 cm)
16-5/8"
(42.2 cm)
18-1/8"
(46 cm)
3/8" (1 cm)
2-7/8" (7.3 cm)
8" (20.3 cm)
1" (2.5 cm)
18"
(45.7 cm)
1-1/2" OD
No change in measurements if connected with drain
illustrated. (K-11677)
Roughing-In
K-1139-HN
PROFLEX
®
6036
CUSTOM BATH WHIRLPOOL WITH HEATER
PROFLEX
®
6036 CUSTOM BATH WHIRLPOOL WITH HEATER
1013752-1-
C