Specification

Optional Accessories
K-1283 Separate apron with removable panel for front access ❑ 0 ❑ Other_____
K-1717 ProFlex
®
20-minute timer kit ❑ NA
K-9696 Jet trim kit (metal finishes) ❑ CP ❑ PB ❑ Other_____
Technical Information
Fixture*:
Basin area:
Bathing well 55″ (139.7 cm) x 21″ (53.3 cm)
Top area 65″ (165.1 cm) x 26″ (66 cm)
To overflow:
Water depth 15″ (38.1 cm)
Capacity 72 gal (272.5 L)
Weight 71 lbs (32.2 kg)
Drop-in cut-out 70-1/2″ (179.1 cm) x 34-1/2″ (87.6 cm)
* Approximate measurements for comparison only.
Pump: Hp V Hz A
1-speed 1.25 120 60 7.5
Heater: kW V Hz A
1.5 120 60 12.5
Required Electrical Service
Two dedicated circuits required, each protected with
Class A Ground-Fault Circuit-Interrupter (GFCI):
Pump/control 120 V, 15 A, 60 Hz
Heater: 120 V, 15 A, 60 Hz
Locate the outlets behind the whirlpool and within
24″ (61 cm) of the pump.
Installation Notes
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of
39 lbs/square foot (189 kg/square meter) loading.
The apron must be installed before the finished floor and wall
materials are installed.
No change in measurements if connected with drain
illustrated. (K-11677 or K-11677M)
Pump/Control Access
(If Apron Is Not Used)
20" (50.8 cm) W x
15" (38.1 cm) H
1-1/4"
(3.2 cm)
Tile Flange
Detail
36" (91.4 cm)
1-1/2"
(3.8 cm)
Drop-In Rim
Detail
20-1/8"
(51.1 cm)
18-5/8"
(47.3 cm)
1-1/2" OD
1/4" (6 mm)
72" (182.9 cm)
8-1/2" (21.6 cm)
1"
(2.5 cm)
18"
(45.7 cm)
3-1/8"
(7.9 cm)
2-7/8" (7.3 cm)
3" (7.6 cm)
Product Diagram
PROFLEX
®
7236
PROFLEX
®
7236 ACRYLIC BATH WHIRLPOOL WITH HEATER
Page2of2
1012988-4-
B