Specification

Technical Information
Fixture*:
Bathing well:
Basin area
bottom
60″ (152.4 cm) x
25-1/2″ (64.8 cm)
Basin area
top
84″ (213.4 cm) x
31-1/2″ (80 cm)
Weight 375 lbs (170 kg)
To overflow:
Water depth 24-5/8″ (62.5 cm)
Capacity 185 gal (700 L)
* Approximate measurements for comparison only.
Recommended spouts*:
Area ″A″ K-8359, K-T954-4, K-T6906, K-18486-4,
K-922 and K-924, K-923 and K-924
Area ″B″ K-922, K-923
* Shaded areas in diagram are recommended installation
location. Area ″B″ is for ceiling mount spouts only.
Required Electrical Service (2)
Two dedicated circuits are required, each protected with
Class A Ground-Fault Circuit-Interrupter (GFCI) or
Earth-Leakage Circuit Breaker (ELCB):
Pump/Control 1.5 hp, 208-240 V, 20 A, 50/60 Hz
Heater 4 kW, 208-240 V, 20 A, 50/60 Hz
Installation Notes
Install this product according to the installation guide.
Two separate 240 V electrical services are required; one for
the pump/control and another for the heater.
Floor support under the bath must provide for a minimum of
3500 lbs (1588 kg).
Consult local and national codes for minimum air gap
requirements when installing a spout on the faucet deck.
The hot water supply should be 70% of the capacity of the
bath or greater. Installations will vary.
Unit must be filled through the bathing well.
A
A
B
51-7/8" (131.8 cm)
103-3/4" (263.5 cm)
41"
(104.1 cm)
20-1/2"
(52.1 cm)
85" (215.9 cm)
3" (7.6 cm)
2-7/8" (7.3 cm)
1" (2.5 cm)
31-13/16"
(80.8 cm)
26-1/2"
(67.3 cm)
23-11/16"
(60.2 cm)
1-1/2" OD
1" (2.5 cm)
1" (2.5 cm)
No change in measurements if connected with
drain illustrated. (K-7223 or K-7223M)
Cut-out: 102-1/4" (259.7 cm) x 40" (101.6 cm)
Pump/Control Access
40" (101.6 cm) W x
15" (38.1 cm) H Min
7" (17.8 cm)
Product Diagram
so¯kTM
so¯kTM OVERFLOWING BATH
Page2of2
1054217-4-
B