Dimensions Guide

60" (1524 mm)
Notes
Required Electrical Service
Measure your actual product for rough-in details.
One dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual Current Device
(RCD).
Install this product according to the installation
instructions.
The hot water supply should be 70% of the
capacity of the bath or greater. Installations will
vary.
220-240 V, 20 A, 50/60 HzBlower, Pump,
Heater:
Technical Information
The pump base extends 10-1/4" (260 mm)
beyond the edge of the rim. Modify the framing
as needed.
All product dimensions are nominal.
Drop-in, Under-mountInstallation:
EndDrain location:
Kit is required for under-mount installations (sold
separately).
42-3/8" x 20" (1076 mm x 508 mm)Basin area, bottom:
54-3/8" x 24-5/16" (1381 mm x 618 mm)Basin area, top:
Drop-in installation requires custom framing.
IMPORTANT! Dry fit the drain assembly prior to
installing the bath. The bath cannot be installed
with all drain components attached.
155 lbs (70.3 kg)Weight:
53.6 lbs/ft² (261.7 kg/m²)Minimum floor load:
15-1/16" (383 mm)Water depth:
For under-mount installations, kit K-531 is
available to order.
59.8 gal (226.4 L)Water capacity:
Drop-in, 59-1/2" x 29-1/2" (1511 mm x
749 mm)
Cutout:
Blower: 240 V, 5 A, 50/60 Hz
Pump: 240 V, 11 A, 50/60 Hz
Heater: 240 V, 50/60 Hz, 1500 W
Electrical component
rating:
1-800-4KOHLER (1-800-456-4537)
Kohler Co. reserves the right to make revisions without notice to product specifications.
For the most current Specification Sheet, go to www.kohler.com.
1-31-2019 10:14 - US/CA/MX
Underscore
®
Rectangle
5' BubbleMassage
™
Whirlpool Bath
K-1167-XH2G