Rough-In Guide

Product Information
Applicable product:
5.5’ bath whirlpool K-1170-H2
Fixture*:
Basin area:
Bathing well 42″ (106.7 cm) x 27″ (68.6 cm)
Top area 54″ (137.2 cm) x 30″ (76.2 cm)
Weight 134 lbs (60.8 kg)
To overflow:
Water depth 16″ (40.6 cm)
Capacity 81 gal (306.6 L)
* Approximate measurements for comparison only.
Drop-in
cut-out
64-1/2″ (163.8 cm) x 40-1/2″ (102.9 cm)
Pump: kW V Hz A
1.5 240 50/60 11
Required accessories:
Jet trim kit K-9698
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual
Current Device (RCD):
Pump/control 220/240 V, 20 A, 50/60 Hz
Installation Notes
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of
44 lbs/square foot (212 kg/square meter) loading.
Hot water supply should be 70% of capacity or greater.
Installations will vary.
If installing a rim-mount faucet, make sure there is no
interference with drain overflow and circulating system before
drilling any holes. Consult local and national codes for
minimum air gap requirements if installing a spout on the
faucet deck.
This whirlpool is designed for drop-in installation only. It is not
suited for use in a three wall alcove with an overhead shower.
Fixture conforms to ANSI Standard Z124.1.2. All dimensions
are nominal.
3" (7.6 cm)
3" (7.6 cm)
2-7/8" (7.3 cm)
66" (167.6 cm)
42" (106.7 cm)
1-1/16" (2.7 cm)
5-1/4" (13.3 cm)
11-3/4"
(29.8 cm)
20-1/8"
(51.1 cm)
1-1/2" OD
33" (83.8 cm)
22"
(55.9 cm)
No change in measurements if connected with drain
illustrated. (K-7161-AF or K-7161M-AF)
Pump/Control Access
34" (86.4 cm) W x
15" (38.1 cm) H
Roughing-In
K-1170-H2
MEMOIRS
®
5.5’ BATH WHIRLPOOL
MEMOIRS
®
5.5’ BATH WHIRLPOOL
1024311-1-
D