Specification Sheet

Pump/Control Access
Notes
Required Electrical Service
Measure your actual product for rough-in details.
One dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual Current Device
(RCD).
Install this product according to the installation
instructions.
The hot water supply should be 70% of the
capacity of the bath or greater. Installations will
vary.
240 V, 20 A, 50/60 HzPump, Heater:
Technical Information
All product dimensions are nominal.
If installing a rim-mount faucet, make sure there
is no interference with drain overflow before
Drop-inInstallation:
Center rearDrain location:
drilling any holes. Consult local and national
42" x 27" (1067 mm x 686 mm)Basin area, bottom:
codes for minimum air gap requirements if
installing a spout on the faucet deck.
54" x 30" (1372 mm x 762 mm)Basin area, top:
134 lbs (60.8 kg)Weight:
This whirlpool is designed for drop-in installation
only. It is not suited for use in a three wall alcove
with an overhead shower.
44 lbs/ft² (214.8 kg/m²)Minimum floor load:
16" (406 mm)Water depth:
81 gal (306.6 L)Water capacity:
Drop-in, 64-1/2" x 40-1/2" (1638 mm x
1029 mm)
Cutout:
Pump: 240 V, 11 A, 50/60 Hz
Heater: 240 V, 6 A, 1500 W
Electrical component
rating:
VariablePump speed:
4-1/4" (108 mm)Minimum flat for door:
USA/Canada: 1-800-4KOHLER (1-800-456-4537)
Kohler Co. reserves the right to make revisions without notice to product specifications.
For the most current Specification Sheet, go to www.kohler.com.
3-7-2017 05:06
Memoirs
®
5.5' Whirlpool Bath
K-1170-H2