Installation Guide

3. Install the Suppy Pipe and Sensor Wire
Install 1/2″ supply pipe to the valve assembly.
At the point where the supply will exit the wall, install a drop ear
ell flush or slightly behind the finished wall.
Feed the sensor wire through the sensor mount and plaster
guard, leaving 1-1/2″ (3.8 cm) minimum of exposed wire hanging
out.
Connect the sensor wire harness to the wall.
Temporarily connect the water supply to the supply ell.
Turn on the water.
Check the system for leaks.
4. Finish the Wall
Install the finished wall.
Make sure holes are created for the sensor wire harness. Location
is optional.
The diameter of the sensor hole cutout is 1-3/8″ (3.5 cm).
Secure wire
harness to the wall.
Plaster Guard
Ell
1-1/2"
(3.8 cm)
1080064-2-A 4 Kohler Co.