Installation Guide

5. Install the Sensor
Install the Bezel
Loosen the screws in the plasterguard.
Remove the plasterguard and discard.
Feed the wiring harness through the back of the bezel.
Position the bezel over the screw heads and turn 1/8 turn
counterclockwise.
Tighten the screws.
Connect the Sensor
Connect the sensor to the wire harness and feed the wire into the
wall.
Position the sensor in front of the bezel with wire on the back of
the sensor to the right.
Push the sensor into place.
Discard the
plasterguard.
Bezel
Sensor Wire
1080064-2-A 6 Kohler Co.