Specification

Technical Information
Fixture*:
Bathing well:
Basin area, bottom 45″ (1143 mm) x 25-1/2″ (648 mm)
Basin area, top 63″ (1600 mm) x 31-1/2″ (800 mm)
Weight 275 lbs (124.7 kg)
To overflow:
Water depth 23-1/2″ (597 mm)
Capacity 142 gal (537.5 L)
* Approximate measurements for comparison only.
Drop-in
cut-out
73-1/2″ (1867 mm) x 39-1/2″ (1003 mm)
Pump: V Hz A
240 50/60 17
Heater: 4 kW 240 50/60 17
Required Electrical Service
Two dedicated circuits required, each protected with
Class A Ground-Fault Circuit-Interrupter (GFCI) or
Residual Current Device (RCD):
Pump/control 208-240 V, 20 A, 50/60 Hz
Heater 208-240 V, 20 A, 50/60 Hz
Installation Notes
Install this product according to the installation guide.
Two separate 240 V electrical services are required; one for
the pump/control, and another for the heater.
Floor support under the overflowing bath must provide for a
minimum of 65 lbs/square foot (317 kg/square meter) loading.
Consult local and national codes for minimum air gap
requirements when installing a spout on the bath deck.
Hot water supply should be 70% of capacity or greater.
Installations will vary.
Unit must be filled through the bathing well.
25"
(635 mm)
31-1/2"
(800 mm)
2"
(51 mm)
1"
(25 mm)
75" (1905 mm)
63" (1600 mm)
5-1/2" (140 mm)
7-1/4"
(184 mm)
16-13/16"
(427 mm)
41"
(1014 mm)
20-1/2"
(521 mm)
1-1/2" NPT
3"
(76 mm)
2-7/8"
(73 mm)
1" (25 mm)
No change in measurements with
drain shown. (K-7193 or K-7193M)
so¯k
®
OVERFLOWING BATH
Page2of2
1019732-4-
(
so¯k
®