Specification

Technical Information
Fixture*:
Basin area
Basin area bottom 47″ (1194 mm) x 20″ (508 mm)
Basin area top 53″ (1346 mm) x 23″ (584 mm)
Weight 100 lbs (45.4 kg)
To overflow
Water depth 14-1/2″ (368 mm)
Capacity 64 gal (242.3 L)
* Approximate measurements for comparison only.
Drop-in cut-out 58-1/2″ (1486 mm) x 30-1/2″ (775 mm)
Pump V Hz A
1-speed 120 60 7.5
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump/control 120 V, 15 A, 60 Hz
Locate the outlet behind the whirlpool and within 24″
(610 mm) of the pump.
Installation Notes
Install this product according to the installation guide.
Floor support under bath whirlpool must provide for a
minimum of 50 lbs/square foot (242 kg/square meter) loading.
The hot water supply should be 70% of the capacity of the
bath or greater. Installations will vary.
Rim-mount faucet installations: Before drilling the mounting
holes, ensure the faucet does not interfere with the drain
overflow and circulating system.
Deck-mount spout installations: Consult local and national
codes for minimum air gap requirements.
The apron must be installed before the finished floor and wall
materials are installed.
No change in measurements if connected with drain
illustrated. (K-7161-AF)
Pump/Control Access
(If Apron Is Not Used)
20" (508 mm) W x
15" (381 mm) H
1-1/4"
(32 mm)
1/2" (13 mm)
R. Max
Integral
Flange Detail
18-1/2"
(470 mm)
3"
(76 mm)
20"
(508 mm)
8-11/16" (221 mm)
1-11/16"
(43 mm)
60" (1524 mm)
3"
(76 mm)
2-7/8"
(73 mm)
1" (25 mm)
32" (813 mm)
16"
(406 mm)
1-1/2" OD
1-1/2"
(38 mm)
Drop-in Rim
Detail
Recommended Faucet Area
Product Diagram
HOURGLASS
®
32
HOURGLASS
®
32 BATH WHIRLPOOL
Page2of2
1014686-4-
F