Specification

Technical Information
Fixture*:
Bathing well:
Basin area, bottom 48″ (1219 mm) x 24″ (610 mm)
Basin area, top 59″ (1499 mm) x 30″ (762 mm)
Weight 116 lbs (52.6 kg)
To overflow:
Water depth 14″ (356 mm)
Capacity 67 gal (253.6 L)
* Approximate measurements for comparison only.
Drop-in cut-out 64″ (1626 mm) x 34″ (864 mm)
VHzA
1-speed pump 120 60 7.5
Heated surface 120 60 1.1
Required Electrical Service
Dedicated circuit required, protected with a Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump/Control/Heated
surface
120 V, 15 A, 60 Hz
Installation Notes
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of
48 lbs/square foot (232 kg/square meter).
If installing a rim-mount faucet, make sure there is no
interference with the drain overflow and circulating system
before drilling any holes. If installing a spout on the faucet
deck, consult local and national codes for minimum air gap
requirements.
The apron must be installed before the finished floor and wall
materials are installed.
Locate a GFCI-protected 120 V, 15A, grounded duplex
electrical outlet within 24″ (610 mm) of the pump.
No change in measurements if connected with drain
illustrated. (K-7161-AF)
Pump/Control Access
(If Apron Is Not Used)
30" (762 mm) W x
15" (381 mm) H
18-1/2"
(470 mm)
20"
(508 mm)
8-11/16" (221 mm)
3"
(76 mm)
2-7/8"
(73 mm)
1" (25 mm)
35-7/8" (911 mm)
3-1/2"
(89 mm)
18"
(457 mm)
66" (1676 mm)
1-1/2" Bath Drain
1-1/4"
(32 mm)
1/2" (13 mm)
R. Max
Integral
Flange Detail
1-1/2"
(38 mm)
Drop-in Rim
Detail
Recommended Faucet Area
1-1/2"
(38 mm)
Lumbar
Angle 42˚
1-1/4"
(32 mm)
20"
(508 mm)
21-1/4"
(540 mm)
Product Diagram
MARIPOSA
®
MARIPOSA
®
5.5’ BATH WHIRLPOOL WITH BASKTM
Page2of2
1201669-4-
A