Specification

Technical Information
Fixture*:
Bathing well:
Basin area, bottom 46 (1168 mm) x 24 (610 mm)
Basin area, top 54 (1372 mm) x 27 (686 mm)
Weight 115 lbs (52.2 kg)
To overflow:
Water depth 14 (356 mm)
Capacity 63 gal (238.5 L)
* Approximate measurements for comparison only.
VHzA
Blower motor 120 60 10
Heated surface 120 60 0.5
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Blower motor/heated
surface
120 V, 15 A, 60 Hz
Installation Notes
Install this product according to the installation guide.
Locate a GFCI-protected 120 V, 15 A, grounded duplex
electrical outlet within 24 (610 mm) of the blower motor.
NOTICE: Relocation of the blower motor and check valve is
optional. Relocate the blower motor and check valve together;
do not move one without the other. An additional access
panel is required for relocation. Provide an access panel at
the blower motor/control location.
Floor support under the bath must provide for a minimum of
44 lbs/square foot (214.8 kg/square meter) loading.
If installing a rim-mount faucet, make sure there is no
interference with drain overflow and circulating system before
drilling any holes. Consult local and national codes for
minimum air gap requirements if installing a spout on the
faucet deck.
No change in measurements with drain
shown. (K-7166-AF)
Recommended faucet area.
1-1/4"
(32 mm)
1/2" (13 mm) R.
1"
(25 mm)
2-7/8"
(73 mm)
4-3/4"
(121 mm)
1-1/4"
(32 mm)
10-1/4"
(260 mm)
18"
(457 mm)
Integral Flange Detail
60" (1524 mm)
3"
(76 mm)
36" (914 mm)
1-1/2" Bath Drain
21-1/4"
(540 mm)
20"
(508 mm)
Lumbar
Angle 33˚
Blower Access
30" (762 mm) W x
15" (381 mm) H
Product Diagram
MARIPOSA
®
MARIPOSA
®
5’ BUBBLEMASSAGETM BATH WITH BASKTM HEATED SURFACE
Page2of2
1201688-4-
A