Specification

Technical Information
Fixture*:
Basin area:
Bathing area, bottom 46″ (1168 mm) x 24″ (610 mm)
Bathing area, top 54″ (1372 mm) x 27″ (686 mm)
Weight 110 lbs (49.9 kg)
To overflow:
Water depth 14″ (356 mm)
Capacity 63 gal (238.5 L)
* Approximate measurements for comparison only.
Drop-in cutout: 58″ (1473 mm) x 34″ (864 mm)
Pump V Hz A
1-speed 120 60 7.5
Heater: Kw V Hz Hz
1.5 120 60 12.5
Required Electrical Service
Two dedicated circuits required, each protected with
Class A Ground-Fault Circuit-Interrupter (GFCI):
Pump/control 120 V, 15 A, 60 Hz
Heater 120 V, 15 A, 60 Hz
Locate the outlets behind the whirlpool and within 24″
(610 mm) of the pump and heater.
Installation Notes
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of
44 lbs/square foot (215 kg/square meter) loading.
If installing a rim-mount faucet, make sure there is no
interference with the drain overflow before drilling any holes.
Consult local and national codes for minimum air gap
requirements if installing a spout on the faucet deck.
The apron must be installed before the finished floor and wall
materials are installed.
No change in measurements if connected with
drain illustrated. (K-7161-AF or K-7161M-AF)
18-1/2"
(470 mm)
20"
(508 mm)
8-11/16"
(221 mm)
1-11/16"
(43 mm)
3"
(76 mm)
2-7/8"
(73 mm)
1" (25 mm)
3-1/2"
(89 mm)
18"
(457 mm)
60" (1524 mm)
1-1/2" OD
36" (914 mm)
Pump/Control Access
(if apron is not used)
20" (508 mm) W x
15" (381 mm) H
1-1/4"
(32 mm)
1/2" (13 mm)
R. Max
Integral
Flange Detail
1-1/2"
(38 mm)
Drop-in Rim
Detail
Recommended Faucet Area
Product Diagram
MARIPOSA
®
MARIPOSA
®
BATH WHIRLPOOL WITH HEATER
Page2of2
1014711-4-
D