Specification

Technical Information
Fixture*:
Basin area:
Bathing well 50″ (1270 mm) x 24″ (610 mm)
Top area 65″ (1651 mm) x 27″ (686 mm)
Weight 102 lbs (47.2 kg)
To overflow:
Water depth 14″ (356 mm)
Capacity 72 gal (272.5 L)
* Approximate measurements for comparison only.
Drop-in cut-out 70″ (1778 mm) x 34″ (864 mm)
Blower
motor:
Heater V Hz A
300 W 120 60 5
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Blower motor: 120 V, 15 A, 60 Hz
Blower motor is supplied with a 24″ (610 mm)
grounding-type plug-in cord.
Installation Notes
NOTICE: If the blower motor and check valve are
relocated, two access panels are required. Locate one
access panel at the blower motor/control location and the
other at the control box. Locate the blower motor and check
valve together.
Install this product according to the installation guide.
Floor support under the bath must provide for a minimum of
41 lbs/square foot (198 kg/square meter) loading.
If used, the optional apron must be installed before the
finished floor and wall materials are installed.
If installing a rim-mount faucet, make sure there is no
interference with drain overflow and circulating system before
drilling any holes. Consult local and national codes for
minimum air gap requirements if installing a spout on the
faucet deck.
1-1/2"
(38 mm)
36" (914 mm)
72" (1829 mm)
1" (25 mm)
3" (76 mm)
1-1/2" OD
2-7/8"
(73 mm)
Blower Access
Integral
Flange Detail
Drop-In Rim Detail
No change in measurements with drain
shown. (K-7166-AF or K-7166M-AF)
Recommended faucet area.
1-1/4"
(32 mm)
1/2" (13 mm) R.
18"
(457mm)
1-13/16"
(46 mm)
10-1/4"
(260 mm)
20" (508 mm) W x
15" (381 mm) H
21-1/4"
(540 mm)
K-1257-GRF
20" (508 mm)
K-1257-GRF
K-1257-G
1-1/4"
(32 mm)
3-1/2"
(89 mm)
18-1/2" (470 mm)
K-1257-G
Product Diagram
MARIPOSA
®
MARIPOSA
®
6’ BUBBLEMASSAGETM BATH
Page2of2
1040121-4-
D