Specification

Technical Information
Fixture*:
Basin area:
Bathing well 50″ (1270 mm) x 24″ (610 mm)
Top area 65″ (1651 mm) x 27″ (686 mm)
Weight 115 lbs (52.2 kg)
To overflow:
Water depth 14″ (356 mm)
Capacity 72 gal (272.5 L)
* Approximate measurements for comparison only.
VHzA
Blower motor 120 60 10
Heated surface 120 60 .5
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI).
Blower motor/Heated surface 120 V, 15 A, 60 Hz
Installation Notes
Install this product according to the installation guide.
Floor support under the bath must provide for a minimum of
41 lbs/square foot (198 kg/square meter) loading.
NOTICE: Relocation of the blower motor and check valve is
optional. Mount the blower motor and check valve together;
do not move one without the other. An additional access
panel is required for relocation. Provide an access panel at
the blower motor/control location.
Locate a GFCI-protected 120 V, 15 A, grounded duplex
electrical outlet within 24″ (610 mm) of the blower motor.
Will comply with ADA when installed per Section 607
Bathtubs of the ADA 2010 Standards for Accessible Design.
36" (914 mm)
1-1/4"
(32 mm)
1-1/2" Bath Drain
3"
(76 mm)
72" (1829 mm)
Integral Flange Detail
18"
(457 mm)
1-1/4"
(32 mm)
3-1/2"
(89 mm)
2-7/8"
(73 mm)
1"
(25 mm)
20"
(508 mm)
1/2" (13 mm) R.
1-1/4"
(32 mm)
Recommended faucet area.
No change in measurements with drain
shown. (K-7166-AF)
10-1/4" (260 mm)
Lumbar
Angle 42˚
18-3/4"
(476 mm)
Product Diagram
MARIPOSA
®
MARIPOSA
®
6’ BUBBLEMASSAGETM BATH WITH INTEGRAL APRON AND BASKTM
Page2of2
1201694-4-
B