Specification

Technical Information
Fixture*:
Basin area:
Bathing well 50″ (1270 mm) x 24″ (610 mm)
Top area 65″ (1651 mm) x 27″ (686 mm)
Weight 108 lbs (49 kg)
To overflow:
Water depth 14″ (356 mm)
Capacity 72 gal (272.5 L)
* Approximate measurements for comparison only.
Drop-in cutout 70″ (1778 mm) x 34″ (864 mm)
VHzA
Blower motor 120 60 10
Heated surface 120 60 .5
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI).
Blower motor/Heated surface 120 V, 15 A, 60 Hz
Installation Notes
Install this product according to the installation guide.
NOTICE: Relocation of the blower motor and check valve is
optional. Mount the blower motor and check valve together;
do not move one without the other. Two access panels are
required for blower motor and check valve relocation. Provide
one access panel at the blower motor/control location and
another at the heated surface location.
Floor support under the bath must provide for a minimum of
41 lbs/square foot (198 kg/square meter) loading.
Locate a GFCI-protected 120 V, 15 A, grounded duplex
electrical outlet within 24″ (610 mm) of the blower motor.
72" (1829 mm)
18"
(457 mm)
10-1/4" (260 mm)
1-1/2"
(38 mm)
1" (25 mm)
3" (76 mm)
2-7/8"
(73 mm)
Integral
Flange Detail
Drop-In Rim Detail
No change in measurements with drain
shown. (K-7166-AF)
Recommended faucet area.
1-1/4"
(32 mm)
1/2" (13 mm) R.
21-1/4"
(540 mm)
20"
(508 mm)
3-1/2"
(89 mm)
Blower Motor Access
30" (762 mm) W x 15" (381 mm) H Min
1-1/4"
(32 mm)
36" (914 mm)
1-1/2"
(38 mm)
1-1/2" Bath Drain
20"
(508 mm)
18-1/2"
(470 mm)
Lumbar
Angle 42˚
Product Diagram
MARIPOSA
®
MARIPOSA
®
6’ BUBBLEMASSAGETM BATH WITH BASKTM
Page2of2
1201695-4-
B