Specification Sheet

21-1/4"
Notes
Required Electrical Service
Measure your actual product for rough-in details.
One circuit required, protected with Class A Ground-Fault
Circuit-Interrupter (GFCI) or Residual Current Device (RCD).
Install this product according to the installation
instructions.
120 V, 15 A, 50/60 HzAmplifier, Heated
Surface:
The hot water supply should be 70% of the
capacity of the bath or greater. Installations will
vary.
Technical Information
All product dimensions are nominal.
If installing a rim-mount faucet, make sure there
is no interference with drain overflow before
3-Wall AlcoveInstallation:
LeftDrain location:
drilling any holes. Consult local and national
50" x 24" (1270 mm x 610 mm)Basin area, bottom:
codes for minimum air gap requirements if
installing a spout on the faucet deck.
65" x 27" (1651 mm x 686 mm)Basin area, top:
88 lbs (39.9 kg)Weight:
Control amplifier fits 16" (406 mm) center studs.
25' (7.6 m) cables are included.
40 lbs/ft² (195.3 kg/m²)Minimum floor load:
14" (356 mm)Water depth:
72 gal (272.5 L)Water capacity:
Amplifier: 120 V, 50/60 Hz, 15 W
Heated Surface: 120 V, 0.5 A, 50/60 Hz,
65 W
Electrical component
rating:
2-1/8" (54 mm)Minimum flat for door:
USA/Canada: 1-800-4KOHLER (1-800-456-4537)
Kohler Co. reserves the right to make revisions without notice to product specifications.
For the most current Specification Sheet, go to www.kohler.com.
10-30-2016 04:09
Mariposa
®
6' VibrAcoustic
®
Bath
K-1257-VBLAW