Installation Guide

Tools and Materials
Before You Begin
Observe all local plumbing and building codes.
Unpack and inspect the apron for damage. Return the apron to the carton until you are ready to
install it.
The apron must be installed before the finished floor and wall materials are installed.
This apron system is designed to have the finished wall materials [1-1/2″ (38 mm) maximum
thickness] go over the apron columns. It is also designed to have the finished floor materials [2″ (51
mm) maximum thickness] butt up against the channel.
The apron can be used as an access to the whirlpool pump and controls, when applicable. However,
additional access may make servicing of the pump and controls easier.
NOTE: Before installing the apron, fill the bath/whirlpool with water and check the drain system for
leaks. If applicable, test the whirlpool system for leaks and proper operation.
Philips
Screwdriver
Flat Blade
Screwdriver
Tape MeasurePencil
Plus:
Construction Adhesive
Conventional Woodworking Tools
and Materials
Support Structure Materials (2x2's or 2x4's)
Shimming Materials (as needed)
Rubber Pads
Square Drill
Drill/bits
Safety Glasses
1018323-2-D 2 Kohler Co.