Installation Guide

1. Install the Faucet
Prepare the Site
NOTE: Before drilling the mounting hole, use the following
provisions for proper placement: (1) A 1-1/4″ (3.2 cm) minimum to
2-1/2″ (6.4 cm) maximum diameter mounting hole is required. (2) A
minimum distance of 1-3/4″ (4.4 cm) is required between the back
of the faucet spout and the wall to allow access to the screw. (3) A
1-1/8″ (2.9 cm) maximum distance is required between the lavatory
basin edge and the base of the faucet spout.
Determine the mounting hole location.
Drill a hole through the mounting surface according to the
surface manufacturer’s instructions.
Install the Faucet
Install the stud to the underside of the faucet.
Slide the gasket over the flexible hoses and stud, then seat the
gasket in the groove on the underside of the spout.
Insert the spout with flexible hoses and stud through the
mounting hole.
From under the lavatory, slide the rubber washer and bracket
onto the stud.
Thread the nut onto the stud to secure the faucet to the mounting
surface.
Without Escutcheon
Spout
Stud
Gasket
Rubber Washer
Bracket
Nut
Supply Hoses
Kohler Co. 3 1102759-2-B