Rough-In Guide

Product Information
Applicable product:
Whirlpool with chromatherapy lights K-1360-H2
Whirlpool without chromatherapy lights K-1360-H3
Fixture*:
Bathing well:
Basin area, bottom 46″ (116.8 cm) x 34″ (86.4 cm)
Basin area, top 57″ (144.8 cm) x 37″ (94 cm)
Weight 215 lbs (98 kg)
To overflow:
Water depth 20″ (50.8 cm)
Capacity 149 gal (564 L)
* Approximate measurements for comparison only.
Pump: (Qty. 2) V Hz A
Variable speed 240 50/60 18
Included components:
Cut-out template 1000153-7
Required accessories:
Jet trim kit K-9398
Grip rails (pair) K-9669
Transfer valve trim* varies
Handshower* varies
Faucet trim kit* varies
Required Electrical Service (2 required)
Two dedicated circuits required, each protected with a Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual Current
Device (RCD):
Pump/control/heater 208-240 V, 20 A, 50/60 Hz
Installation Notes
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of 63
lbs/square foot (309 kg/square meter) loading.
Two separate 240 V electrical services required; one for the
pump/control, and another for the heater.
Consult local and national codes for minimum air gap
requirements when installing a spout on the faucet deck.
Hot water supply should be 70% of capacity or greater.
Installations will vary.
Fixture conforms to ANSI Standard Z124.1.2. All dimensions are
nominal.
2" OD
32-3/4" (83.2 cm)
10"
(25.4 cm)
2-3/4" (7 cm)
45"(114.3 cm)
11/16"
(1.7 cm)
1-1/4" (3.2 cm)
7" (17.8 cm)
2" (5.1 cm)
11-1/2" (29.2 cm)
75" (190.5 cm)
17-1/2" (44.5 cm)
3-1/2" (8.9 cm)
3" (7.6 cm)
Drop-in cut-out 73-1/2" (186.7 cm)
x 43-1/2" (110.5 cm)
No change in measurements with drain
shown. (K-7167 or K-7167M)
21-5/8" (54.9 cm)
Cold/Valve
(Supplied)
Hot/Valve
(Supplied)
3/4" (1.9 cm) D.
Supply To Valves
Valve Detail
Handshower
1-1/4" (3.2 cm)D. Hole
(Not Supplied)
Transfer Valve
(Supplied)
2-1/2"
(6.4 cm)
Pump/Control Access
45" (114.3 cm) W x
18" (45.7 cm) H Min
25"
(63.5 cm)
3"
(7.6 cm)
K-1360-H3
1022211-1-D 2 Kohler Co.