Rough-In Guide

Product Information
Applicable product:
6’ Experience bath whirlpool with Massage
Package
K-1418-M
Fixture*:
Basin area:
Bathing area, bottom 42″ (106.7 cm) x 27″ (68.6 cm)
Bathing area, top 60″ (152.4 cm) x 30″ (76.2 cm)
Weight 140 lbs (64 kg)
To overflow:
Water depth 16″ (40.6 cm)
Capacity 86 gal (326 L)
* Approximate measurements for comparison only.
Pump: kW V A*
1.5 240 15
* Approximate measurements for comparison only.
Drop-in
cut-out
70-1/2″ (179.1 cm) x 40-1/2″ (102.9 cm)
Minimum access panel (required):
Pump/control 34″ (86.4 cm) W x 15″ (38.1 cm) H
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual
Current Device (RCD):
Pump/control 208-240 V, 20 A, 50/60 Hz
Installation Notes
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of
44 lbs/square foot (214 kg/square meter) loading.
Hot water supply should be 70% of capacity or greater.
Installations will vary.
If installing a rim-mount faucet, make sure there is no
interference with drain overflow and circulating system before
drilling any holes. Consult local and national codes for
minimum air gap requirements if installing a spout on the
faucet deck.
This whirlpool is designed for drop-in installation only. It is not
suited for use in a three wall alcove with an overhead shower.
Fixture conforms to ANSI Standard Z124.1.2. All dimensions
are nominal.
11-3/4"
(29.8 cm)
36" (91.4 cm)
5-1/4" (13.3 cm)
72" (182.9 cm)
3" (7.6 cm)
20-1/8"
(51.1 cm)
1-1/2" OD
1-1/16" (2.7 cm)
22"
(55.9 cm)
Pump/Control Access
42" (106.7 cm)
2-7/8"
(7.3 cm)
3" (7.6 cm)
Roughing-In
K-1418-M
MEMOIRS
®
6’ EXPERIENCE BATH WHIRLPOOL WITH MASSAGE PACKAGE
MEMOIRS
®
6’ EXPERIENCE BATH WHIRLPOOL WITH MASSAGE PACKAGE
1025516-1-
E