Installation Guide

1010448-2-D
4
Kohler Co.
ALL DRAINS
S Insert the stopper into the flange.
S Remove the body nut from the seal
hole.
S Fit the short end of the rod into the
body seal hole and under the stopper
for regular installations; through the
hole for vandal-resistant installations.
S Loosely secure in place with the body
nut.
S Remove and adjust the stopper so the
stopper lifts about 3/8” (1cm) when
opened. To adjust, loosen the stopper
nut and shorten or lengthen the
stopper as needed. Re-tighten the
stopper nut.
S Hand-tighten the body nut.
S Apply thread sealant to the tailpiece.
Thread the tailpiece into the body and
securely hand-tighten.
Stopper
Rod
Seal Hole
Body
Nut
Apply Thread
Sealant
Tailpiece
Stopper
Nut
Body
S Slide the clip and the link onto the rod
with the thumb screw facing toward
the back of the bidet.
S To move the link to the proper
position, squeeze the clip and slide it
along the rod.
S Push the rod down (open position).
Thumb
Screw
Link
Clip
Rod
S Slide the lift rod through the hole in the
lift rod escutcheon and then into the
hole in the link.
S Tighten the thumb screw on the link so
the lift rod knob is 1/2” (1.3cm) above
the lift rod escutcheon.
1/2”
(1.3cm)
Thumb
Screw
Lift Rod Knob
Link
Lift Rod
Escutcheon