Installation Guide

7
Kohler Co.
1010448-2-D
HOSE CONNECTIONS
S Connect the plastic flexible hose from
the transfer valve to the shank of the
spray head assembly using thread
sealant.
Spray Head
Assembly
Shank
Apply thread
sealant
Plastic
Flexible
Hose
S Connect the braided hoses from the
end body valves to the supply tee.
NOTE: Position the hose/supply tee
assembly to avoid interference with the
drain mechanism before tightening.
S Connect the other end of the supply
tee hose to the transfer valve/vacuum
breaker. Use the gasket at the
connection.
Supply Tee
Gasket
Transfer Valve/
Vacuum Breaker
End Body
Valve
IF THE BIDET IS NOT INSTALLED, INSTALL IT AT THIS TIME. BE
SURE TO FOLLOW ALL INSTRUCTIONS PACKED WITH THE
BIDET.
SUPPLIES AND STOPS
S Identify your supply connection type.
Connect the supply tubes to the end
body valves and supply stops. (Left is
hot - right is cold.)
S Tighten all connections.
HOT
COLD
Union
Compression
Nut