Installation Guide

1. Install the Lavatory
Drill a 2-3/4″ (7 cm) hole, using the supplied template, at the
desired installation location.
Position the O-ring and lavatory on the cutout hole.
Make sure the washer is in place on the bronze nut.
Apply a continuous bead of thread sealant to the bronze nut.
Thread the bronze nut into the lavatory from underneath the
countertop.
Wrench tighten the nut. Take care to avoid scratching the lavatory.
Attach the drain following the drain manufacturer’s instructions.
Lavatory
Countertop
O-Ring
Washer
Bronze Nut
2-3/4" (7 cm) Hole
Kohler Co. 3 1058339-2-B