Installation Guide

1014299-2-B
5
Kohler Co.
Flange
Apply Plumbers
Putty
Seal
Drain Body
Gasket
Screw
Link
Spring Clip
Nut
Tailpiece
Rod
Body Washer
Lavatory
Stopper
Washer
Nut
Seal
Apply 3 layers
of sealant tape
to bottom 2/3
Apply 3 layers of
sealant tape and
a small bead of
pipe sealant to
threads
3. Drain Installation
- Disassemble the drain components.
- Remove the protective material from the flange.
- Wrap the bottom 2/3 of the flange threads with three layers of sealant
tape.
- Apply a ring of plumbers putty or other sealant to the underside of
the flange according to putty manufacturer’s instructions. Insert the
flange into the lavatory drain hole.
- Assemble the gasket (tapered side up) and washer to the flange and
partially thread the nut to the flange. Do not fully tighten the nut at
this time.
- Install the body washer and body with the seal hole facing the back of
the lavatory and tighten.
- Ensure the seal hole is facing the back of the lavatory and fully tighten
the nut using care to avoid scratching the finish.
- Remove any excess putty or sealant.
- Insert the stopper into the flange.