Installation Guide

1010448-2-D
2
Kohler Co.
COMPONENT LOCATIONS
SPRAY ASSEMBLY
S Remove the spray head and flange
from the shank.
S Thread the nut and washers to the
bottom of the shank.
S From the underside of the bidet, insert
the shank up through the bidet spray
hole.
S From the top of the bidet, thread the
flange onto the shank.
S Thread the spray head as far as it will
go onto the shank, and thread the
flange until it is snug against the spray
head.
S Wrench-tighten the nut on the shank.
Spray Head
Flange
Nut
Bidet
Shank
Rubber
Washer
Metal Washer
LIFT ROD ESCUTCHEON
S Apply a bead of plumbers putty around
the underside of the escutcheon.
Insert the escutcheon through the hole
in the bidet.
S Assemble the washer (tapered side
up), brass washer, and nut to the
escutcheon.
S Wrench-tighten the nut.
S Remove any excess plumbers putty.
Nut
Washer
Brass Washer
Escutcheon
Apply Plumbers
Putty