Specification

Technical Information
Fixture*:
Basin area:
Bathing well,
bottom
50″ (1270 mm) x 29″ (737 mm)
Bathing well, top 61″ (1549 mm) x 32″ (813 mm)
Weight 128 lbs (58.1 kg)
To overflow:
Water depth 16″ (406 mm)
Capacity 100 gal (378.5 L)
* Approximate measurements for comparison only.
Included components:
Cut-out template 113311-7
Blower
motor /
control:
kW V Hz A
300 220-240 50/60 3
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual
Current Device (RCD):
Blower motor/control 220-240 V, 15 A, 50/60 Hz
Installation Notes
The blower motor and piping protrude beyond the rim.
Install this product according to the installation guide.
Floor support under bath must provide for a minimum of 51
lbs/square foot (247 kg/square meter).
Hot water supply should be 70% of capacity or greater.
Installations will vary.
If installing a rim mount faucet, make sure there is no
interference with drain overflow and circulating system before
drilling any holes. Consult local and national codes for
minimum air gap requirements if installing a spout on the
faucet deck.
This bath is designed for drop-in installation only. It is not
suited for use in a three wall alcove with an overhead shower.
A blower motor/control access panel is required.
1-1/2" OD
2-7/8" (73 mm)
3" (76 mm)
3-1/2" (89 mm)
42" (1067 mm)
13-1/2"
(343 mm)
6-1/2" (165 mm)
33-1/2"
(851 mm)
67" (1702 mm)
Note: The blower and piping protrude beyond the rim.
2"
(51 mm)
No change in measurements with drain
shown. (K-7161-AF or K-7161M-AF )
Recommended faucet area.
K-1457-GCR
3" (76 mm) x 24" (610 mm)
Flat Faucet Deck
Blower/Control Access
34" (864 mm) W x
15" (381 mm) H Max
22"
(559 mm)
1-1/2"
(38 mm)
Product Diagram
PORTRAIT
®
5.5’
PORTRAIT
®
5.5’ BUBBLEMASSAGETM BATH WITH AIRJETS
Page2of2
1038563-4-
D