Specification

Technical Information
Fixture*:
Bathing well:
Basin area, bottom 50″ (1270 mm) x 29″ (737 mm)
Basin area, top 61″ (1549 mm) x 32″ (813 mm)
Weight 130 lbs (59 kg)
To overflow:
Water depth 16″ (406 mm)
Capacity 100 gal (378.5 L)
* Approximate measurements for comparison only.
Pump kW V A*
1.5 240 11
* Approximate measurements for comparison only.
Included component:
Cut-out template 113311-7
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual
Current Device (RCD):
Pump/control 208-240 V, 20 A, 50/60 Hz
Installation Notes
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of
48 lbs/square foot (231 kg/square meter) loading.
Hot water supply should be 70% of capacity or greater.
Installations will vary.
If installing a rim-mount faucet, make sure there is no
interference with drain overflow and circulating system before
drilling any holes. Consult local and national codes for
minimum air gap requirements if installing a spout on the
faucet deck.
Pump must be relocated to custom position at the time of
installation. Provide adequate clearance.
10" (254 mm) Max
1-1/2" OD
No change in measurements if connected with drain
illustrated. (K-7161-AF or K-7161M-AF)
Recommended faucet area.
K-1457-HF Pump/Control
Access 34" (864 mm) W x
15" (381 mm) H
K-1457-HJ
Pump/Control Access
34" (864 mm) W x
15" (381 mm) H
8" (203 mm)
Max
10" (254 mm) Max
13-1/2"
(343 mm)
12" (305 mm)
Max
K-1457-HB Pump/Control Access
34" (864 mm) W x 15" (381 mm) H
K-1457-HN
Pump/Control Access
34" (864 mm) W x
15" (381 mm) H
33-1/2"
(851 mm)
6-1/2"
(165 mm)
2"
(51 mm)
2-7/8" (73 mm)
3" (76 mm)
3-1/2" (89 mm)
42" (1067 mm)
67" (1702 mm)
3" (76 mm) x 24" (610 mm)
Flat Faucet Deck
22"
(559 mm)
Product Diagram
PORTRAIT
®
PORTRAIT
®
5.5’ CUSTOM BATH WHIRLPOOL
Page2of2
1019745-4-
G