Specification

(cont.) Optional Accessories
K-1703 Remote control ❑ NA
K-9498 3″ (76 mm) whirlpool keypad trim ❑ CP ❑ PB ❑ Other_____
K-1013469 Trim ring, interface, core ❑ CP ❑ PB ❑ Other_____
Technical Information
Fixture*:
Bathing well:
Basin area,
bottom
44-1/2″ (1130 mm) x 22-5/16″
(567 mm)
Basin area, top 59-5/8″ (1514 mm) x 25-1/2″ (648 mm)
Weight 117 lbs (53.1 kg)
To overflow:
Water depth 18″ (457 mm)
Capacity 85.8 gal (325 L)
* Approximate measurements for comparison only.
VHzA
Blower motor/Heated surface 220-240 50/60 5
Drop-in cutout 64-1/2″ (1638 mm) x 30-1/2″ (775 mm)
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual
Current Device (RCD):
Blower motor/Heated
surface
220-240 V, 15 A, 50/60 Hz
Installation Notes
Install this product according to the installation guide.
Floor support under bath must provide for a minimum of 50
lbs/square foot (242 kg/square meter) loading.
Hot water supply should be 70% of capacity or greater.
Installations will vary.
1"
(25 mm)
66" (1676 mm)
22"
(559 mm)
32" (813 mm)
2-7/16"
(62 mm)
16"
(406 mm)
16-3/4"
(425 mm)
13/16"
(21 mm
4-1/8"
(105 mm)
No change in measurement if connected with
drain illustrated. (K-7272)
1-1/2" Bath Drain
Blower Motor/Control Access
30" (762 mm) W x
15" (381 mm) H Min
Lumbar
Angle 40˚
21"
(533 mm)
Product Diagram
UNDERSCORE
®
UNDERSCORE
®
5.5’ BUBBLEMASSAGETM BATH WITH BASKTM
Page2of2
1201702-4-
B