Dimensions Guide

K-1446 Recommended Accessories: Remote blower/motor installation kit NA
Technical Information
Fixture: Approximate measurements for comparison only.
Bathing well:
Basin area, bottom 45-1/8″ (1146 mm) x
19-11/16″ (500 mm)
Basin area, top 52-1/8″ (1324 mm) x
22-1/16″ (560 mm)
Weight 87 lbs (39.4 kg)
To overflow:
Water depth 15-1/8″ (384 mm)
Capacity 57 gal (215.7 L)
Drop-in cutout 58-1/2″ (1486 mm) x 28-1/2″ (724 mm)
Blower motor Heater V Hz A
300 W 120 60 10
Heated surface 120 60 0.5
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Blower motor: 120 V, 15 A, 60 Hz
Installation Notes
Install this product according to the installation guide.
Locate a GFCI-protected 120 V, 15 A, grounded duplex
electrical outlet within 24″ (610 mm) of the bath junction box.
A40″ (1016 mm) cable is included.
Floor support under this product must provide for a minimum
of 47 lbs/square foot (229 kg/square meter) loading.
The hot water supply should be 70% of the capacity of the
bath or greater. Installations will vary.
Will comply with ADA when installed per Section 607
Bathtubs of the ADA 2010 Standards for Accessible Design.
1-1/2"
Bath Drain
60" (1524 mm)
30" (762 mm)
No change in measurements if connected
with drain illustrated. (K-7271 or K-7272)
3/4" (19 mm)
2-1/2"
(64 mm)
11-1/4"
(286 mm)
15"
(381 mm)
4-1/8"
(105 mm)
1-1/2"
(38 mm)
Drop-in Rim
Detail
1-1/4"
(32 mm)
Blower Motor Access
30" (762 mm) W x 15" (381 mm) H
Lumbar
Angle 24˚
1/2" (13 mm) R.
1-1/4"
(32 mm)
Integral Flange
Detail
19"
(483 mm)
K-1947-GW
20-1/4"
(514 mm)
K-1947-GLW
K-1947-GRW
Product Diagram
ARCHER
®
ARCHER
®
5’ BUBBLEMASSAGETM BATH WITH BASKTM
Page2of2
1215948-4-
A