Rough In Guide

Product Information
Applicable product:
Bath whirlpool – drop-in K-1947-H
Bath whirlpool – integral flange, left drain K-1947-LH
Bath whirlpool – integral flange, right drain K-1947-RH
Fixture*:
Bathing well
Basin area,
bottom
45-1/8″ (1146 mm) x
19-11/16″ (500 mm)
Basin area top 52-1/8″ (1324 mm) x 22-1/16″ (560 mm)
Weight 98 lbs (44.5 kg)
To overflow
Water depth 15-1/8″ (384 mm)
Capacity 57 gal (216.9 L)
* Approximate measurements for comparison only.
Drop-in cutout 58-1/2″ (1486 mm) x 28-1/2″ (724 mm)
Pump: V Hz A
1-speed 120 60 7
Heater: kW V Hz A
1.5 120 60 12.5
Required accessories:
Clearflo slotted overflow brass bath drain OR K-7271
Clearflo slotted overflow bath drain – PVC pipe K-7272
Required Electrical Service
Two dedicated circuits required, each protected with
Class A Ground-Fault Circuit-Interrupter (GFCI):
Pump/control 120 V, 15 A, 60 Hz
Heater 120 V, 15 A, 60 Hz
Installation Notes
Install this product according to the installation guide.
Pump is supplied with 24″ (610 mm) grounding-type plug-in
cord.
Floor support under this product must provide for a minimum
of 48 lbs/square foot (234 kg/square meter) loading.
The hot water supply should be 70% of the capacity of the
bath or greater. Installations will vary.
Will comply with ADA when installed per Section 607
Bathtubs of the Act.
Fixture conforms to CSA B45.5/IAPMO Z124. All dimensions
are nominal.
1-1/2"
Bath Drain
60" (1524 mm) 30" (762 mm)
No change in measurements if connected
with drain illustrated. (K-7272)
3/4" (19 mm)
2-1/2"
(64 mm)
11-1/4"
(286 mm)
15"
(381 mm)
4-1/8"
(105 mm)
1-1/2"
(38 mm)
Drop-in Rim
Detail
1-1/4"
(32 mm)
Pump/Control Access
20" (508 mm) W x 15" (381 mm) H
Lumbar Angle 24˚
1/2" (13 mm) R.
1-1/4"
(32 mm)
Integral Flange
Detail
19"
(483 mm)
K-1947-H
20-1/4"
(514 mm)
K-1947-LH
K-1947-RH
Roughing-In
K-1947-H, K-1947-LH, K-1947-RH
ARCHER
®
5’ BATH WHIRLPOOL WITH HEATER
ARCHER
®
5’ BATH WHIRLPOOL WITH HEATER
1208010-1-
A